PurePro Industrial / Commercial RO units
Whole Home, Commercial and Industrial RO
As people become increasingly aware of the benefits of purified
water, the demand for equipment capable of treating both municipal
and well water supplies continues to grow. As a result, Whole House
and Commercial Reverse Osmosis systems are becoming widely accepted.
We carry a wide variety of RO systems, one of which will fit your
application and your budget.
High Quality, Low Cost: PurePro Industrial RO
Series is designed to provide high-quality water for residential and
commercial applications with a low cost.
PurePro Series 1500
- 48,000 GPD
Conservative Design Approach: High quality systems built to meet
your flow requirements on start-up and continue to meet that same
requirement for years of service. PUREPRO
Series 500 - 30,000 GPD
Fully equipped and customizable: PurePro USA
reverse osmosis systems feature an excellent pre-treatment design,
high quality components, and high overall performance.Whole House
Reverse Osmosis Systems
A typical Whole House Reverse Osmosis System includes the following
main components:
Reverse Osmosis Unit to produce the daily household requirements.
For example, a 500 gallon-per-day system would produce purified
water at the rate of about 20 gallons per hour. Since 20 gallons per
hour is not enough to supply the demands of all normal household
functions, a supplementary storage system is required so that ample
water will be on hand when needed.
Storage Tank. An atmospheric (non-pressurized) storage tank large
enough to provide ample water for daily activities. The reverse
osmosis unit refills the tank as water is taken from it. The water
is stored at atmospheric pressure and must, therefore, be
re-pressurized for use.
Re-pressurization System. This system can consist simply of a pump
that comes on automatically when water is needed and supplies
pressurized water to the home. Ideally, however,it should include a
smaller bladder or diaphragm tank that is filled to house pressure
by a pump and gives a more even supply of water when the demand
arises.
The following diagram illustrates the three main components of a
whole house reverse osmosis system, as described above.
Water Purification Systems for Small to Medium-sized Water Store or
Bottling Plant
Excel Water Technologies can provide packaged Reverse Osmosis
systems with capacities ranging from 800 GPD to 12,000 GPD and up.
These systems are ideal for small and medium-sized water stores or
bottling operations.
Wherever good water purity is required, our systems will typically
output water in the 2 to 10 PPM TDS range. This assumes an input
water TDS under 1000 PPM.
In order to produce a product which meets the required water quality
standards, commercial Reverse Osmosis systems must integrate various
processing stages. The following chart describes these stages.
The equipment required for these various stages can be purchased
"stand-alone", or separately, if needed. More usually, and more
economically, we will supply an integrated, or "turnkey" system, in
which the needed stages and equipment are pre-connected and tested.
Preconditioning Stage
The proper preconditioning of your water is critical to the smooth
and safe operation of your business. Improperly treated input water
can cause serious damage to the various components of your reverse
osmosis system, and would surely compromise the quality of your
product water.
A complete analysis of your incoming water supply is essential. This
will determine what elements are present and what pre-treatment is
necessary to remedy any problems.
A typical standard preconditioning package consists of:
Multi-media filter to remove sediment and particulate matter
Water softener to eliminate excess mineral content
Carbon filter to remove any organic chemicals (chlorine, pesticides,
etc.)
These systems are available "stand-alone" or as part of a "turnkey"
package.
In some cases, additional preconditioning may be needed. For
example, the presence of bacteria or iron in the incoming water
would require treatment with ultraviolet light and specialized iron
filters, respectively.
Disinfection Stage
The disinfection stage is an essential component of any drinking
water processing operation. Since the water exiting the reverse
osmosis system will be stored in a closed tank, it is susceptible to
stagnation and biological contamination.
To remedy this, some combination of Ultraviolet and/or Ozone
disinfection is required. As in the preconditioning stage, this
equipment can be purchased "stand-alone" if needed. However, some of
the reverse osmosis systems we supply (see below) are optionally
configurable with UV and Ozone modules.
Reverse Osmosis Stage
The main focus of our commercial reverse osmosis systems is the
small to medium-sized water store or bottling operation.
The typical water store requirement will be in the 800-3000 gallon
per day range. Bottling operations will generally require
1500-12,000 GPD capacity and higher.
Stand-alone Reverse Osmosis Systems
(no preconditioning or disinfection)
